I am slowly learning how to use this marvelous software. I've managed to figure out how to correctly use most of the modules but the Alignment module is still giving me problems. I am using a Meade LX90 8" scope with a .66 reducer and a Meade DSI 2 pro camera for guiding and do my main imaging right now using a Atik 314L mono camera with a WO 66 scope.
In the alignment module I can arrive at solutions with the Meade DSI2 and the LX90 w/ reducer. This combination results in a small fov which often results in not arriving at a solution. I have tried using the Atik but that does not work right as I can't seem to find a way to get the program to recognize that I am using the Atik with the WO66, so it applies the 1320 mm FL of the LX90 reducer combo instead of the 388 mm fl of the WO66.
So the question is can someone tell me how to do this? I have tried setting up the program as shown on the attached screen saves but this does not work. Any help would be appreciated.
Thanks
Jon
In the alignment module I can arrive at solutions with the Meade DSI2 and the LX90 w/ reducer. This combination results in a small fov which often results in not arriving at a solution. I have tried using the Atik but that does not work right as I can't seem to find a way to get the program to recognize that I am using the Atik with the WO66, so it applies the 1320 mm FL of the LX90 reducer combo instead of the 388 mm fl of the WO66.
So the question is can someone tell me how to do this? I have tried setting up the program as shown on the attached screen saves but this does not work. Any help would be appreciated.
Thanks
Jon