This morning I wanted to do some dark files at home.
I connected only my camera to the USB3 plug.
I started kstats then ekos then indi with only the camera and connected it.
Doing the first image in the picture tab. All was good until the downloading of the picture that was looping infinitely.
As yesterday all was fine, I was a little bit surprised.
I tested 2 cables : same result.
I reinstalled all : same result.
In all case the log file shows no problem.
Finally something that was an evidence: the fits viewer never opened after the image upload.
I connected a simulator mount. Does a fake alignment. The fit viewer rises. And then I can take dark pictures.
So, my conclusion is that with only a camera the capture tab is unable to open the fit viewer. Am I right ?
I connected only my camera to the USB3 plug.
I started kstats then ekos then indi with only the camera and connected it.
Doing the first image in the picture tab. All was good until the downloading of the picture that was looping infinitely.
As yesterday all was fine, I was a little bit surprised.
I tested 2 cables : same result.
I reinstalled all : same result.
In all case the log file shows no problem.
Finally something that was an evidence: the fits viewer never opened after the image upload.
I connected a simulator mount. Does a fake alignment. The fit viewer rises. And then I can take dark pictures.
So, my conclusion is that with only a camera the capture tab is unable to open the fit viewer. Am I right ?