Hi there,
I am running my Onstep controller (version 1.15g alpha) through a Raspberry Pi.
When I connect to /dev/ttyACM0, the alignment, slewing etc works well.
However if I connect through the Wifi, it doesn't work so well. The INDI driver can connect and talk to the mount, set the time/coordinates etc.
But, nothing happens when I click "1-Star" / Manual Align, also when I click the "North", "South", "East" and "West" buttons, an error "Error stopping N/S" or "..."E/W motion" will be produced.
Any clues as to what is happening?
Thanks!
I am running my Onstep controller (version 1.15g alpha) through a Raspberry Pi.
When I connect to /dev/ttyACM0, the alignment, slewing etc works well.
However if I connect through the Wifi, it doesn't work so well. The INDI driver can connect and talk to the mount, set the time/coordinates etc.
But, nothing happens when I click "1-Star" / Manual Align, also when I click the "North", "South", "East" and "West" buttons, an error "Error stopping N/S" or "..."E/W motion" will be produced.
Any clues as to what is happening?
Thanks!