Hi, either it's too late or I had to little coffee today, but how can I make settings persistent.
i.e. I want to set the guiding rate to 0.3 for the EQMOD driver. But every time I re-boot it comes up at 0.5
similar with the gphoto2 / Canon driver. Is there a way to toggle 'actions/viewfinder/ON' at connect?
I already logged the XML comms and copy pasted snippets into the configuration file, but it seems that 'load' is followed by a 'save' and all changes vanish. If I put the same snippets in the default config, no changes to the addressed fields can be noticed.
I'm sure there is a way of doing this, but I'm to blunt to figure it![:(]( ":(")
best
Niko
i.e. I want to set the guiding rate to 0.3 for the EQMOD driver. But every time I re-boot it comes up at 0.5
similar with the gphoto2 / Canon driver. Is there a way to toggle 'actions/viewfinder/ON' at connect?
I already logged the XML comms and copy pasted snippets into the configuration file, but it seems that 'load' is followed by a 'save' and all changes vanish. If I put the same snippets in the default config, no changes to the addressed fields can be noticed.
I'm sure there is a way of doing this, but I'm to blunt to figure it
best
Niko