I'm having a bit of trouble getting indi_lx200basic controls to work with my DIY mount. My diy mount program uses the url=http://www.meade.com/support/LX200CommandSet.pdf]LX200 Command set[/url and reacts when I send it serial commands over the arduino monitor. When I connect to indi_lx200basic the mount will react to sync and goto, but when I push the NSEW buttons I get the message "Telescope does not support North/South motion." The driver doesn't appear to be sending usb commands when it reports this. Can anybody tell me where the system determines motion control availability?
Since I'm working with my own telescope "firmware" I'm assuming the problem is somewhere in my code/responses, and I'm hoping to get a better understanding of what my serial setup needs to do to wake up these functions. I.e. sending a different ID response etc.
First guy to say buy a different mount gets the pointy stick.![:pinch:]( ":pinch:")
Since I'm working with my own telescope "firmware" I'm assuming the problem is somewhere in my code/responses, and I'm hoping to get a better understanding of what my serial setup needs to do to wake up these functions. I.e. sending a different ID response etc.
First guy to say buy a different mount gets the pointy stick.
